JPexamの問題集を購入したら、あなたの試験合格率が100%を保証いたします。もし試験に失敗したら、弊社が全額で返金いたします。
IT業種は急激に発展しているこの時代で、IT専門家を称賛しなければならないです。彼らは自身が持っている先端技術で色々な便利を作ってくれます。それに、会社に大量な人的·物的資源を節約させると同時に、案外のうまい効果を取得しました。彼らの給料は言うまでもなく高いです。そのような人になりたいのですか。羨ましいですか。心配することはないです。JPexamのHPのHP0-207トレーニング資料はあなたに期待するものを与えますから。JPexamを選ぶのは、成功を選ぶということになります。
君はまだHP HP0-207認証試験を通じての大きい難度が悩んでいますか？ 君はまだHP HP0-207認証試験に合格するために寝食を忘れて頑張って復習しますか？ 早くてHP HP0-207認証試験を通りたいですか？JPexamを選択しましょう！JPexamはきみのIT夢に向かって力になりますよ。
HPのHP0-207認定試験に関連する知識を学んで自分のスキルを向上させ、HP0-207認証資格を通して他人の認可を得たいですか。HPの認定試験はあなたが自分自身のレベルを高めることができます。HP0-207認定試験の資格を取ったら、あなたがより良く仕事をすることができます。この試験が非常に困難ですが、実は試験の準備時に一生懸命である必要はありません。JPexamのHP0-207問題集を利用してから、一回で試験に合格することができるだけでなく、試験に必要な技能を身につけることもできます。
試験番号：HP0-207問題集
試験科目：Procurve Adaptive EDGE Fundamentals
最近更新時間：2013-12-26
問題と解答：全120問
100％の返金保証。1年間の無料アップデート。
HP HP0-207認証試験に合格することが簡単ではなくて、HP HP0-207証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。
しかし、HP0-207試験は簡単ではありません。専門的な知識が必要で、もしあなたはまだこの方面の知識を欠かれば、JPexamは君に向ける知識を提供いたします。JPexamの専門家チームは彼らの知識や経験を利用してあなたの知識を広めることを助けています。そしてあなたにHP0-207試験に関するテスト問題と解答が分析して差し上げるうちにあなたのIT専門知識を固めています。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.jpexam.com/HP0-207_exam.html
NO.1 What are the primary solution categories of the Adaptive EDGE Architecture? Select THREE.
A.mobility
B.security
C.reliability
D.availability
E.upgradeability
F.convergence
G.cost-effectiveness
Correct:A B F
HP HP0-207 HP0-207練習問題
NO.2 You are about to update the software on a ProCurve switch. Which command do you use to view
a list of all software versions stored on the switch?
A.show run
B.show flash
C.show startup
D.show version
Correct:B
HP HP0-207 HP0-207練習問題
NO.3 A customer is planning a Power over Ethernet deployment for a large call center that will use
VoIP telephones. While planning the wiring closets for the deployment, the customer suggests
using the uplink ports of a ProCurve Switch 2650-PWR to provide power to a ProCurve Switch
2600-8-PWR. Which statement describes a correct response to this suggestion?
A.It is only possible if the second switch is a ProCurve Switch 2626-PWR.
B.It is not possible because the 2600-8-PWR cannot act as a Powered Device.
C.It is only possible if the customer adds a ProCurve 600 EPS/RPS to the first switch.
D.It is not recommended because the second switch will not have adequate power redundancy.
Correct:B
HP HP0-207 HP0-207練習問題
NO.4 You are configuring a ProCurve Layer 2 switch to obtain time information from an SNTP server
located on a different IP network than the switch. Which configuration steps are necessary on the
switch to enable this functionality?
A.The switch cannot be configured to obtain time information from a server on a different IP network.
B.Define a default gateway for the switch, enable SNTP, use the sntp server command to enter the IP
address of the server.
C.Assign a port on the switch to a VLAN that includes the SNTP server, enable SNTP, configure the
switch for SNTP unicast mode.
D.Configure an IP address on the same IP network as the SNTP server, enable TimeP, configure the
switch for SNTP broadcast mode.
Correct:B
HP HP0-207 HP0-207練習問題
NO.5 You are implementing a fully connected HP Switch Mesh at a customer site. Which statement
describes a valid design guideline for HP Switch Meshing?
A.A switch may be connected to no more than four mesh domains.
B.Up to five Switch 5400zl Series switches can be included in a full mesh.
C.All links in a full mesh must operate at the same speed and use the same media type.
D.When a switch is configured for HP Switch Meshing protocol, all of the ports on that switch must
participate in the mesh.
Correct:B
HP HP0-207 HP0-207練習問題
NO.6 While using the CLI to configure a ProCurve switch, you must move from the global
configuration level to the port context configuration level for port a1. Which command do you use?
A.port a1
B.ethernet a1
C.interface a1
D.configure a1
Correct:C
HP HP0-207 HP0-207練習問題
NO.7 At a customer site, you have configured four ProCurve switches for HP Switch Meshing and
Multiple Spanning Tree Protocol. How will the mesh appear to non-mesh switches in the same
spanning tree domain?
A.as a single device
B.as a set of devices without redundant links
C.as devices that cannot participate in the spanning tree
D.as a set of devices with spanning tree enabled to block redundant links
Correct:A
HP HP0-207 HP0-207練習問題
NO.8 You are assigned to configure ProCurve switches at a customer site for in-band management.
Which are in-band management methods? Select TWO.
A.Telnet
B.SNMP
C.XMODEM
D.serial console
E.menu interface
Correct:A B
HP HP0-207 HP0-207練習問題
NO.9 You configured Rapid Spanning Tree Protocol on four ProCurve Switch 5348xl switches at a
customer site. During the configuration, you forgot to configure the switches so that
switch-to-switch links are not defined as edge ports. Which statement describes the consequence
of your oversight?
A.The switches in the spanning tree will elect multiple Root bridges.
B.The switches will reject the spanning tree configuration and block all ports until the configuration is
corrected.
C.The switches will be unable to elect a Root bridge and will not be able to forward traffic until the
configuration is corrected.
D.The switches will require more time to elect the Root bridge and resolve the topology, but the spanning
tree will otherwise function normally.
Correct:D
HP HP0-207 HP0-207練習問題
NO.10 How do ProCurve switches, configured with link aggregation (also known as port trunking),
handle broadcast traffic?
A.Broadcast traffic is flooded through all of the ports in the trunk.
B.The switch sends a query and receives permission from potential receivers before flooding.
C.Broadcast traffic is handled in exactly the same way it would be without port trunking configured.
D.Broadcast traffic is flooded through non-trunked ports, but forwarded only through one of the ports in
the trunk.
Correct:D
HP HP0-207 HP0-207練習問題
NO.11 You must update the software on a customer's ProCurve Switch 5412zl. Which statement
correctly describes the process for this operation? Select TWO.
A.Use TFTP for direct serial transfer of the software.
B.Use FTP for in-band transfer of the software through an IP network.
C.Use TFTP for in-band transfer of the software through an IP network.
D.Transfer the software from your workstation using a direct serial transfer.
E.Instruct the switch to search for any available TFTP server without knowing its IP address.
Correct:C D
HP HP0-207 HP0-207練習問題
NO.12 How is traffic prioritization accomplished with IEEE 802.1p?
A.802.1Q-compliant devices enforce priorities based on VLAN ID.
B.802.1Q-compliant devices set one of 8 values in a 3-bit field in the VLAN tag.
C.802.1Q-compliant devices set one of 64 values in a 6-bit field in the IP datagram header.
D.802.1Q-compliant devices dedicate a portion of available bandwidth to each prioritized conversation.
Correct:B
HP HP0-207 HP0-207練習問題
NO.13 You are installing a ProCurve switch at a customer site and must enable remote management
for network administrators. Which configuration parameter is necessary to ensure that
administrators can manage the switch even if they are on different IP networks?
A.default VLAN
B.default gateway
C.default password
D.default management profile
Correct:B
HP HP0-207 HP0-207練習問題
NO.14 You have been asked to configure IGMP on a ProCurve Switch 6200yl at a customer site. What
are the steps for enabling IGMP on the switch?
A.Enter the manager level, then issue the ip igmp command.
B.Enter the global configuration context, then issue the ip igmp command.
C.Enter the VLAN context for each VLAN that will support IGMP, then issue the ip igmp command.
D.Enter the interface configuration context for each port configured with a VLAN, then issue the ip igmp
command.
Correct:C
HP HP0-207 HP0-207練習問題
NO.15 While using the CLI to configure a ProCurve switch, you must change context from the manager
level to the global configuration level. Which command do you use?
A.exit
B.write
C.global
D.enable
E.configure
Correct:E
HP HP0-207 HP0-207練習問題
NO.16 You are about to configure HP Switch Meshing on four ProCurve switches at a customer site.
All of the ports that will be included in the mesh are configured for membership in customer
VLANs. How will the mesh configuration affect the VLAN configuration?
A.The mesh ports will automatically become a tagged member of all configured VLANs.
B.The mesh ports will not be a member of any VLANs until you manually configure its VLAN assignments.
C.The mesh ports will not be 802.1Q-compliant and will only be able to retain membership in a single
untagged VLAN.
D.The mesh ports will automatically become a member of the default VLAN and must be configured for
other VLAN membership.
Correct:A
HP HP0-207 HP0-207練習問題
NO.17 On switches that support the Switch Setup screen interface, which parameters can be
configured on the Switch Setup screen? Select TWO.
A.STP bridge priority
B.IP address of the TACACS+ server
C.system name and contact information
D.IP address and subnet mask for each VLAN
E.IP address and subnet mask for the default VLAN
Correct:C E
HP HP0-207 HP0-207練習問題
NO.18 While examining the spanning tree configuration on a ProCurve switch, you notice that one of
the ports is in the Blocking state. Which statement describes how this port will function in this
state?
A.The port is completely blocked for all purposes.
B.The switch will not forward user traffic through that port, but will forward telnet traffic.
C.The switch will not forward user traffic through that port, but will forward BPDUs through that port.
D.The switch forwards user traffic through that port, but does not receive user traffic through that port.
Correct:C
HP HP0-207 HP0-207練習問題
NO.19 You must remotely manage a customer's switch using Telnet. Which configuration/monitoring
interfaces are available? Select TWO.
A.web interface
B.menu interface
C.ProCurve Manager
D.boot monitor interface
E.command line interface
Correct:B E
HP HP0-207 HP0-207練習問題
NO.20 What are the key principles of the Adaptive EDGE architecture? Select TWO.
A.Control to the Edge
B.Control to the Desktop
C.Command from the Center
D.Management from Anywhere
E.Security throughout the Network
Correct:A C
HP HP0-207 HP0-207練習問題
JPexamは最新の642-447問題集と高品質のHP0-Y46問題と回答を提供します。JPexamのHP0-J62 VCEテストエンジンとLOT-406試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質の000-588 PDFトレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100％保証します。試験に合格して認証資格を取るのはそのような簡単なことです。
没有评论:
发表评论